Abrasive belts with zirconium corundum enable aggressive material removal during belt grinding thanks to their excellent cutting effect and the active grinding additives. A grinding-active additional layer (top size) increases the cutting performance many times over during dry grinding and enormously reduces the processing temperature at the grinding point.

Abrasive belts with zirconium corundum therefore have a wide range of applications. They are ideally used for processing unalloyed and low-alloy steel, high-alloy steel, cast iron, aluminum alloys, brass and bronze.

• Continuous peak performance
  Continuous high-performance processes through optimal utilization of the sanding belt. A particular advantage is that the ceramic grain sharpens itself over and over again during belt grinding and thus retains its aggressiveness.

• Very high removal rate
  The sanding belt with zirconium corundum almost completely prevents clogging. Additional grinding additives make a decisive contribution to a very high removal rate and a long service life of the sanding belt. Better removal rates can only be achieved with sanding belts with ceramic grain.

• Maximum cost minimization
  Saving work steps and thus labor costs through faster processing of workpieces while improving the surface quality justify the use of grinding belts with zirconium corundum.

Picard tip: Choosing the right contact disc
The use of sanding belts with ceramic grain should always be done in conjunction with the correct contact wheel. For dry grinding, we recommend our FAPI-KS/V FREQUENCY DAMPED contact wheel, which can achieve up to 40% more removal rate. For wet grinding, we recommend our FAPI-PA FREQUENCY DAMPED contact wheel, which can also be used to achieve an enormous increase in removal rate.